starspirit2018
New member
- Joined
- Jun 20, 2025
- Messages
- 3
- Reaction score
- 0
NEW K1C PRINTER STOPPED EXTRUDING
Basically this is what happened. Printer has been working fine. Then on one small simple print, I noticed it said it was done but only printed half of the model. So I checked the slicer, in case I had it set up only to print to a certain layer. No, it was fine and configured to do a complete print.
Then I reprinted the model, and the printer started, however with no extrusion.
So I verified there were no clogs and even changed the hot end nozzle.
In doing that, I noticed the drive gears were not functioning. No movement or noise.
Please, please help. How do I troubleshoot and get a new print head drive if necessary.
Thanks for your help.
Regards,
Scott Gurule'
my email is [email protected]
Basically this is what happened. Printer has been working fine. Then on one small simple print, I noticed it said it was done but only printed half of the model. So I checked the slicer, in case I had it set up only to print to a certain layer. No, it was fine and configured to do a complete print.
Then I reprinted the model, and the printer started, however with no extrusion.
So I verified there were no clogs and even changed the hot end nozzle.
In doing that, I noticed the drive gears were not functioning. No movement or noise.
Please, please help. How do I troubleshoot and get a new print head drive if necessary.
Thanks for your help.
Regards,
Scott Gurule'
my email is [email protected]