Recent content by fattsmassive

Anyone know the specs on the lidar cable for the k1max? or atleast what and where I can get the parts to put one together mnself?

Any help would be great... I'm not sure where to start... I've done a few calibration tests, but it's seems like a hit or miss....

Hey, so I'be owned a few printers in the past few years, but i'm far from a expert.... I still need help from time to time, but other than that, 3d printing is cool.

Chillaxin!

I tried to print something else and it came out fine and used the same settings… not sure what to think atm… mixed feelings, lol. Sort of like a relationship and the other half is hiding something from you… this sucks…

Here are the settings I used during those prints, =

I recently replaced the mobo on my K1 Max due to a bricked board. The install went fine, all wires are where they should be. No issues with the firmware install either, it all went smooth. After configuring my K1, I tried to do a couple of calibration prints to see if it was good to go… first...