I've had a creality ender 3 s1 plus for about 6 months. When I do the self-leveling, the probe goes along and touches like 12 points around the bed.
If I go into auxillary level and check it with the plastic sheet that came with the printer, in some spots the sheet is snug under the nozzle but in others, it's not even touching.
I end up having to go around all five points in Aux. and adjust tension on the spring wheels. This doesn't really save me a lot of time.
I thought the leveling program was designed to compensate in the Z axis all over the bed so if the bed were out of level a bit, it would adjust the Z axis in the program accordingly to maintain Z0.0 from where it probed. Is this not how it works?
Thanks
If I go into auxillary level and check it with the plastic sheet that came with the printer, in some spots the sheet is snug under the nozzle but in others, it's not even touching.
I end up having to go around all five points in Aux. and adjust tension on the spring wheels. This doesn't really save me a lot of time.
I thought the leveling program was designed to compensate in the Z axis all over the bed so if the bed were out of level a bit, it would adjust the Z axis in the program accordingly to maintain Z0.0 from where it probed. Is this not how it works?
Thanks